Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮Australia Post Priority Dispatch📮Free Shipping Australia wide📮

Troubleshooting

Something not right? Usually a 30-second fix.

Nearly everything we hear about comes down to a seal ring in the wrong spot or an adapter that needs one more turn. Work through these first. Still stuck? Email a photo and we'll sort it.

Leaking from the middle

Wobbly or leaking at the tap

Leaking from the middle?

Put a seal between the two halves.

Unscrew the two halves

Twist the filter apart where the body joins.

Fit a filter seal

Place the thickest seal ring between the two halves. Extra seals are in the box.

Screw back together

Hand-tight is enough. Run the tap and check the join.

Alt image

Watch: sealing the InFlow Tap Filter.

Why it happens

The seal ring is what makes the join watertight. If it was left out, is the thin one, or has shifted, water finds the gap. Swap in the thick ring and the leak stops.

Wobbly or leaking at the tap?

Check the large flat ring.

The large flat ring sits under the adapter, between the adapter and the tap. If it's missing, or in upside down, the filter won't seat flat and will wobble or drip at the top.

1. Take the filter off the tap

Unscrew it and look at the adapter.

2. Fit the large flat ring the right way up

Flat face against the tap. The photo shows where it sits.

3. Check the adapter size

If it still wobbles, the adapter is probably one size out. The sizing chart is on the setup guide.

Stainless Steel Pro

Using the metal adapters.

Pick male or female

Thread inside your tap: male adapter. Thread on the outside: female adapter.

Screw it into the blue M22 adapter

Larger end first, into the blue M22 female adapter.

Attach to the filter

Make sure the large flat ring is in place and the right way up, then screw the filter on hand-tight.

No thread on your tap?

Use the universal adapter.

Some taps have a smooth spout with nothing to screw onto. The universal clamp-on adapter in the box handles most of them.

1. Slide the wide end over the spout

The rubber sleeve wraps around the end of the tap.

2. Tighten the hose clamp

A flathead screwdriver or a butter knife does it. Snug, not crushing.

3. Screw the threaded end into the M22 adapter

Then set up the filter as normal.

Alt image

Watch: universal adapter installation.

Other quick checks

Four more things people ask.

Flow has dropped

The cartridge may be due. They last 3 to 6 months on the tap filters, and the cartridge changing colour is the sign to swap it. Refills are on the refills page.

Display not lighting up

The Tap Filter display is hydropowered. No batteries to change, it lights while water is running through the filter.

Not sure which adapter

Every adapter has its size engraved on the side. Outside thread takes a female adapter, inside thread takes a male one. The full chart is on the setup guide.

Want to see it done

There is a setup video for every filter and tap type, a couple of minutes each, on the setup guide.

Still not right? Send us a photo.

A photo of the filter on your tap tells us most of what we need. We'll reply with the fix, or send out the part you're missing.

Email a photo

Setup guide